Tineco FLOOR ONE S5 COMBO Serie Mode D'emploi page 27

* Do not recline more than 142° to protect
against water leakage.
Fig.C-2
3.Place the appliance on the charging base
vertically after use for recharge and storage.
Fig.C-3
Note:
• Selecting the appropriate mode depending
on the CWT contents is vital for maximum dirt
detection effectiveness.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the
appliance will switch off in 3 seconds after
power off.
Filling Clean Water Tank
1.Press the Clean Water Tank release button to
remove it from the appliance.
Fig.C-4
2.Open the tank cap, and fill with tap water to
the Max line. When deep cleaning is necessary,
add one bottle cap of solution to the CWT and
tightly close the cap.
Fig.C-5
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
3.Place the tank back into the appliance. You
should hear a "Click" if done correctly.
Fig.C-6
Charging Instructions
To charge the appliance, place the appliance on
the charging base and plug the adaptor into a
power outlet.
1.Connect the external charging cord to the
charging base and plug it into the wall outlet.
2.To avoid tripping hazards, please place the
appliance on the charging base near a wall
during charging.
Fig.C-7
Warning:
• Only charge the appliance with the adaptor
supplied by Tineco.
• During long periods of not being used, the
appliance must be charged once every 3
months for optimal performance.
• Store indoors in a dry place. Do not expose the
appliance to sunlight or freezing temperatures.
Recommended temperature range:
39.2°F (4°C) ~ 104°F (40°C).
Cleaning Mode Selection
AUTO Mode
• In AUTO mode, the iLoop sensor automatically
detects how dirty the floor is and applies the
appropriate amount of detergent and suction
power.
• A red dirt monitoring loop indicates more dirt
is detected, and a blue loop indicates less dirt
is detected. This mode automatically provides
the best cleaning solution.
Fig.C-8
MAX Mode
• In AUTO mode, press the
MAX mode.
• In Max mode, the appliance will apply max
suction power and will spray water/solution for
deeper cleaning.
Fig.C-9
ECO Mode (Hand Vac)
• When the main body is used as a hand vac, the
appliance will start in ECO mode by default.
Fig.C-10
MAX Mode (Hand Vac)
• Press the button to switch to MAX mode
while using the hand vac.
Fig.C-11
Note:
Keep sharp objects away from the digital display
screen to avoid scratches and scrapes.
25
button to enter