Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Completely fill the lid (5) of the cleaning ball container (4) with cleaning balls (approx. 20...25
balls).
7.
Now pour the cleaning balls from above into the DGMa module (2) of the CLO sensor.
8.
Refit the CLO sensor into the DGMa module (2).
9.
Open the feed and drain valves of your bypass fitting and set the flow at 60 ... 80 l/h.
The flow of water carries the cleaning balls to the sensor head, abrasively cleaning the
ð
surfaces of the electrodes.
Cleaning set CLO/DGMa for sensor types CLO
7
Publicité
Table des Matières
