Maintenance; Cleaning And Inspection; Ashes; Thermotte™ Plates - Nordpeis Quadro Basic Série Manuel D'installation Et D'utilisation

experience, but after a little while a natural rhythm for
the fire will be found.
IMPORTANT! Always remember to open the air
vent control (preferably also the door) when new
wood logs are inserted into a hot burn chamber.
Let the flames get established on the wood before
the draught is reduced.
When the draught in the chimney is low and
the vents are closed, the gas from the firewood
can be ignited with a bang. This can cause
damages to the product as well as the immediate
environment.

6. Maintenance

Cleaning and Inspection

The stove should be inspected thoroughly and cleaned
at least once per season (possibly in combination
with the sweeping of the chimney and chimney pipes).
Ensure that all joints are tight and that the gaskets are
rightly positioned. Exchange any gaskets that are worn
or deformed. Remember that the stove must always be
cold when inspected.

Ashes

The ashes should be removed at regular intervals.
Be aware that the ashes can contain hot ember even
several days after the fire is finished. Use a container
of non-combustible material to remove the ashes. It is
recommended to leave a layer of ashes in the bottom
as this further insulates the burn chamber. Take care
with the Thermotte plates when the ashes are removed,
particularly when using an ash shovel, so as not to
damage them.
Thermotte™ Plates
The insulation plates (Thermotte - FIG 5) are classified
as "wear and tear" parts which will require to be
exchanged after some years. The wear time will depend
on the individual use of your product.
Nordpeis offers a one-year warranty on these parts.
After this, replacements can be purchased.
If new plates are needed, contact your dealer.
In case the Thermotte plates need to be replaced see
FIG 6-10.
A. Smoke baffle
B. Side plate
C.
Back plate
D. Side plate
E. Log-stopper
F. Lower plate
Please note: Wood logs that are too long can cause
strain and crack the plates, due to the tension created
between the side plates.
12

Door and glass

Should there be any soot on the glass it may be
necessary to clean it. Use dedicated glass cleaner.
(NB! Be careful, detergents can damage the varnish).
If different detergents are used they may damage the
glass. A good advice for cleaning the glass is to use a
damp cloth or kitchen roll paper and apply some ash
from the burn chamber. Rub around the ash on the
glass and finish off with a piece of clean and damp
kitchen roll paper. NB! Only clean when the glass is
cold.
Periodically, it may be necessary to change the gaskets
on the door to ensure that the burn chamber is air tight
and working optimally. These gaskets can be bought as
a set including ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain

Recycling of the ceramic glass

Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass, must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. In case it would be mixed with ordinary
glass, it would damage the raw material and could, in
worst case end the recycling of glass. It is an important
contribution to the environment to ensure that ceramic
glass does not end up with the recycling of ordinary
glass.
Packaging recycle
The packaging accompanying the product should be
recycled according to national regulations.

7. Warranty

For detailed description of the warranty conditions
see the enclosed warranty card or visit our website
www.nordpeis.com
Use replacement parts recommended only by the
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
GB
Warning!
Manufacturer.
Warning!