Maintenance; Cleaning And Inspection; Ashes; Thermotte™ Insulating Plates - Nordpeis SN-ME000-C34 Manuel D'installation Et D'utilisation

IMPORTANT! Always remember to open the air
vent control when new wood logs are inserted
into a hot burn chamber. Let the flames get
established on the wood before the air supply is
When the draught in the chimney is low and
the vents are closed, the gas from the firewood
can be ignited with a bang. This can cause
damages to the product as well as the immediate
environment.

6. Maintenance

Cleaning and inspection

The stove should be inspected thoroughly and cleaned
at least once per season (possibly in combination
with the sweeping of the chimney and chimney pipes).
Ensure that all joints are tight and that the gaskets are
rightly positioned. Exchange any gaskets that are worn
or deformed.
Remember that the stove must always be cold
when inspected.

Ashes

The ashes should be removed at regular intervals.
Be aware that the ashes can contain hot ember even
several days after the fire is finished. Use a container
of non-combustible material to remove the ashes. It is
recommended to leave a layer of ashes in the bottom
as this further insulates the burn chamber. Take care
with the Thermotte plates when the ashes are removed,
particularly when using an ash shovel, so as not to
damage them.
Thermotte™ insulating plates
The insulation plates (Thermotte - FIG 5b) are classified
as "wear and tear" parts which will require to be
exchanged after some years. The wear time will depend
on the individual use of your product.
Nordpeis offers a one-year warranty on these parts.
After this, replacements can be purchased.
If new plates are needed, contact your dealer:
A. Baffle plate
B. Back plate
C. Fire plate
D. Right bottom plate
E. Left bottom plate
F. Lateral plate right - w/o side glass (*)
G. Lateral plate left - w/o side glass (*)
Please note: Wood logs that are too long can cause
strain and crack the plates, due to the tension created
between the side plates.
18
reduced.

Door and glass

Should there be any soot on the glass it may be
necessary to clean it.
other detergents may damage the glass. (Attention!
Be careful, even dedicated glass cleaner can damage
the varnish on the door
cleaning the glass is to use a damp cloth or kitchen roll
paper and apply some ash from the burn chamber.
Rub around the ash on the glass and finish off with a
piece of clean and damp kitchen roll paper. Attention!
Only clean when the glass is cold.
Check regularly that the transition between the glass
and the door is completely tight. Periodically, it may be
necessary to change the gaskets on the door to ensure
that the burn chamber is air tight and working optimally.
These gaskets can be bought as a set, usually including
ceramic glue.
CERAMIC GLASS
CANNOT BE
RECYCLED
Ceramic glass should
be disposed of as resid-
ual waste, together with
pottery and porcelain
Recycling of the ceramic glass
Ceramic glass cannot be recycled. Old glass, breakage
or otherwise unusable ceramic glass, must be discarded
as residual waste. Ceramic glass has a higher melting
temperature, and can therefore not be recycled together
with glass. In case it would be mixed with ordinary
glass, it would damage the raw material and could, in
worst case end the recycling of glass. It is an important
contribution to the environment to ensure that ceramic
glass does not end up with the recycling of ordinary
glass.
Packaging recycle
The packaging accompanying the product should be
recycled according to national regulations.

7. Warranty

Use replacement parts recommended only by
the Manufacturer.
Any unauthorized modification of the appliance
without written permission of the Manufacturer
are prohibited.
For detailed description of the warranty conditions see the
enclosed warranty card or visit our website:
www.nordpeis.com
GB
Use dedicated glass cleaner, as
frame). A good advice for
Warning!
Warning!