Changing A Watering Program; Manual Watering; Reset; Shutting Off The Timer - claber Tempo Select 8486 Notice D'instructions

Table des Matières

Les langues disponibles

Programming

Changing a watering program

Repeat the programming procedure as indicated under

gram"

on page 10; the new program selected will replace the previous

one, with no further steps required.

1. Press the "maNUaL" button and hold it for at least 3 seconds ->

when the timer goes into manual mode, the word oFF will blink.

2. Within 1 minute, press the "StaRt" button to activate the preset 5

minute watering cycle in which the symbol

length of watering cycle in manual mode is preset at 5 minutes and can

not be modified. To stop watering within the 5 minutes, press "StaRt"

again and the word oFF will blink.

3. To exit the manual function, make sure that the valve is off, then press

the "maNUaL" button and hold it for at least 3 seconds.

When in manual mode, the watering cycle in progress will be sus-

pended but the program itself will not be cancelled or changed.

The factory settings of the timer can be restored at any given moment

by pressing the "maNUaL" and "StaRt" buttons simultaneously and

holding them for at least 10 seconds.

If the timer needs to be switched off at any point in time, press the "F"

button until the word "oFF" appears, then press "StaRt".

"Selecting a pro-

will appear. Warning:

Table des Matières

Table des Matières