Basic Troubleshooting - claber Tempo Select 8486 Notice D'instructions

Basic troubleshooting

US
The following table indicates a few simple steps that can be taken safely
to address any faults or malfunctions that may occur during normal use of
the watering system.
PRoBLEm
Timer does not
work (blank
display )
Timer is working
(backlit display)
but program is
not watering
Umbrella symbol
blinking: the
timer has re-
ceived no com-
munication from
the RF sensor
for more than
24 hours.
For further assistance contact Claber Customer Service at 1-800-930-4566
or via email at info@claberinc.com.
18
SoLUtIoNS
The batteries are dead, or not installed correctly
mation see "Batteries installation" on page 6).
No water supply: make sure that faucet is on.
Rain sensor tripped
with Rain Sensor" on page 14).
Check:
- the state of the timer filter, clean it if necessary
information see "Cleaning and maintenance" on page 17);
- the watering line is properly connected.
Check:
- the batteries of the RF Rain Sensor are charged (if the LED
of the RF Rain Sensor is blinking red, or not lit, the batteries
are dead);
- the conditions are right for RF communication: make sure
there are no large obstacles between the RF Rain Sensor and
the timer, and that the RF Rain Sensor is positioned no more
than 100 ft. (30 m) from it;
- the RF Rain Sensor is where originally installed.
(For further information see "Operation
(For further infor-
(For further