Replacing Voices - Viscount Chorale 8 Mode D'emploi

Owner's Manual Chorale 8
Viscount

6.2 REPLACING VOICES

As described at the start of this section, the Chorale 8 has an interesting, useful voice replacement function.
The organ has a vast internal library of voices, comprising various variations on the original voices.
To recall this function, select the ALTERNATIVE VOICE option from the VOICES submenu; the display
will show the first screen:
in which you have to select the section of the organ containing the stop of the voice to be replaced, or
keeping pressed the stop itself on the front panel (as if to switch it on). In the first case the display shows
the first four voices in the section selected.
while if you press the stop the display shows the screen shown below.
Now use the [FIELD ] and [FIELD ] buttons to select the voice you wish to replace. After locating
the cursor on the voice concerned, press [ENTER].
The top of the display contains information concerning the voice you are about to replace, while the
central part of the screen shows the possible replacement registers for that specific stop.
Here again, you can use the [FIELD ] and [FIELD ] buttons to scroll through all the replacement
voices, which are rendered audible immediately for quicker programming by just moving the cursor over
the fields of the voices displayed.
Once you have found the voice you require, press [ENTER]:
57