Owner's Manual
There is also a piston marked [HR] (Handle Registers) beside the general combinations; also known
as 0, when it is on it automatically memorises the register status. This piston's main function is to
restore, during use of the combinations, the "hand-made" stop setup created when the [HR] button
was on. Remember that an HR setup is not modified if the stops are switched on and off by hand when
a combination on the same section is selected (i.e. with the HR off).
N.B.
The contents of the HR are not retained when the organ is switched off.
Each combination (including HR and Tutti) is able to store:
-
the status (on/off) of the stops
-
the status of the couplers
-
the status of the tremulants (even with different modulation depths and speeds, if the specific
SET-UP menu function described in par. 7.8 is activated)
-
the style (Organ Style)
-
the MIDI controls (point 2) and the Program Changes set using the SEND PROGRAM
CHANGE function (par. 8.2)
-
Enclosed and Automatic Pedal (activating the specific function, see par. 7.8).
For the fixing combinations procedure, see point 1.
5. [VOL.] piston: used to display the divisional volumes of each section of the organ.
6. [MENU] piston: used to display the organ setup functions menu.
7. [A.P.] piston: this piston controls the status of the Automatic Pedal function used to play the stops of
the pedal board using the first 32 notes of Man.II. In this case, the organ's pedal board is deactivated
and the stops become monophonic, with priority to the lowest note.
8. [ENC] piston: pressing this piston activates the Enclosed function used to control the organ's general
volume using the swell pedal [MAN. III].
N.B.
When the Enclosed function is activated, the volumes of the first manual and pedal board are
immediately set in relation to the position of the [MAN. III] swell pedal. When the Enclosed function
is deactivated, the volume of the third manual is immediately readjusted in relation to the position of
the [MAN. I] swell pedal, while those of the pedal board and second manual are set in accordance
with the setting in the VOLUMES function (see chap. 4).
9. [T] piston: piston used for switching the Tutti on and off. The voice composition of the Tutti function
is programmable. To set a new configuration, switch on the stops and couplers of your choice, press
[S], keep it pressed and then press the [T] piston or the [TUTTI] foot piston.
10. [C] piston: Cancel piston, which switches off all the stops, tremulants, couplers and pistons on any
manual divisions active, then resets the HR.
45
Chorale 8
Viscount