BFT THALIA Instructions D'installation page 36

Logic Definition
Configuration of
SAFE 1 safety input SAFE 1.
Configuration of
SAFE 2 safety input SAFE 2.
Configuration of
IC 1 command input IC 1.
Configuration of
IC 2 command input IC 2.
Configuration of
AUX 3 AUX 3 output.
FIXED CODE Fixed code
Transmitter
RADIO PROG
programming
Serial mode
SERIAL MODE (Identifies how board
is configured in a BFT
network connection).
ADDRESS Address
36 -
THALIA
INSTALLATION MANUAL
Cross out
Default setting
used
0
72
6
74
0
61
4
62
0
26-37
0
1
0
[ ___ ]
0
0 Input configured as Phot (photocell).
1 Input configured as Phot test (tested photocell).
2 Input configured as Phot op (photocell active during opening only).
3 Input configured as Phot op test (tested photocell active during opening only).
4 Input configured as Phot cl (photocell active during closing only).
5 Input configured as Phot cl test (tested photocell active during closing only).
6 Input configured as Bar, safety edge.
7 Input configured as Bar, tested safety edge.
8 Input configured as Bar 8k2.
0 Input configured as Start E.
1 Input configured as Start I.
2 Input configured as Open.
3 Input configured as Close.
4 Input configured as Ped.
5 Input configured as Timer.
6 Input configured as Timer Pedestrian.
0 Output configured as 2nd Radio Channel.
1 Output configured as SCA (gate open light).
2 Output configured as Courtesy Light command.
3 Output configured as Zone Light command.
4 Output configured as Stair Light
5 Output configured as Alarm
6 Output configured as Flashing light
7 Output configured as Latch
8 Output configured as Magnetic lock
Receiver is configured for operation in rolling-code mode.
0
Fixed-Code Clones are not accepted.
Receiver is configured for operation in fixed-code mode.
1
Fixed-Code Clones are accepted.
Disables wireless memorizing of transmitters.
0 Transmitters are memorized only using the relevant Radio menu.
IMPORTANT: Disables the automatic addition of new transmitters, clones and replays.
Enables wireless memorizing of transmitters:
1- Press in sequence the hidden key and normal key (T1-T2-T3-T4) of a transmitter that has already
been memorized in standard mode via the radio menu.
1 2- Press within 10s the hidden key and normal key (T1-T2-T3-T4) of a transmitter to be memorized.
The receiver exits programming mode after 10s: you can use this time to enter other new transmitters.
This mode does not require access to the control panel.
IMPORTANT: Enables the automatic addition of new transmitters, clones and replays.
0 Standard SLAVE: board receives and communicates commands/diagnostics/etc.
Standard MASTER: board sends activation commands (START, OPEN, CLOSE, PED, STOP) to other
1
boards.
Identifies board address from 0 to 127 in a local BFT network connection.
(see U-LINK OPTIONAL MODULES section)
Optional extras