Possible Malfunctions, Their Causes And Remedies - Schaerer Opal Mode D'emploi

SCHAERER OPAL
6. When the cleaning indicator (2a) and
themonitor lamp both begin to blink
simultaneously, rinse out the water
tank thoroughly, fill it with fresh water
and put it back in position Fill the water
tank with cold water, taking care not
to fill it above 1-2 cm below the rim.
7. Now press the cleaning button
again, and the entire system will be
flushed with fresh water. (If the red con-
trol lamp (2a) is still illuminated but the
water tank is already empty, fill ap-
proximately 1 litre of water into the wa-
ter tank and replace it.). Once the signal
lamp (2a) and descaling icon
no longer lit up, turn the hot water /
steam dial to centre position and re-
place the grounds container. The appli-
ance is now free of limescale and ready
to dispense coffee.
Iportant: Regular descaling will protect your
coffee maker from expensive repairs. Any
damage to the appliance resulting from
omission of this treatment, failure to follow
the correct procedure or
compliance with these instructions is ex-
cluded from warranty cover. The use of
vinegar for descaling purposes is expressly
prohibited as this would damage the coffee
maker
14.0 Possible malfunctions, their causes
and remedies
Please read the following information carefully before you send your coffee
maker back for repair. This will often solve the problem and save you a lot of
time and trouble.
BAOP - 02 - V04
(2)
(16) are
from non-
1. Appliance does not respond when the
- The 0-1 mains power switch is not switched on.
- The power cable is not properly connected or you have a defective
fuse.
2. The indicator flashes
- The brewing unit is not correctly inserted or the service access hatch
is not properly closed - check these.
The indicator and a number light up on the programming dis-
play.
- A malfunction has occurred which must be repaired by an authorised
specialist.
3. Flashing or permanently lit signal lamps or icons
- Please refer to the section explaining the meaning of these mes-
sages.
4. The pump emits a loud noise and / or the
- The water tank is incorrectly positioned and there is air in the system.
Reposition the water tank correctly and purge the system of air by
turning the hot water / steam dial to the hot water position until water
flows out steadily. Then return the dial to centre position and the icon
will go out when you press a coffee selection button.
Note: It is normal for the water pump to start up occasionally when the
appliance is operating. It constantly refills the system automatically.
5. The coffee obtained has no froth
- You are using an unsuitable coffee blend or the coffee is stale.
- The quantity of coffee you have set to be ground is too small.
- The cups are too cold, use the preheating function.
- You did not wait for the appliance to reach its correct operating tem-
perature.
User instruction
switch is pressed
indicator lights up
Page 69