LENCO CR-16 Mode D'emploi page 9

skipped during automatic tuning.
- If the automatic tuning does not stop on the exact frequency
of the station, for example, it stops on 88.9 MHz instead of
88.8 MHz, use the manual tuning method to "fine tune" to the
exact frequency of the desired station.
HINTS FOR BEST RECEPTION
FM - To insure maximum FM tuner reception, unwrap and fully
extend the EXTERNAL FM WIRE ANTENNA for best FM radio
reception.
TO SET/RECALL RADIO STATION PRESETS
1. Press the << or >> button to select the desired radio station.
2. Press and hold the MEMORY button, the next available preset
memory number will flash on the LED display. (Note: "P01"
will flash in the display if you are programming presets for the
first time.)
3. Press the << or >> button to change to the desired preset
number P01 thru P10.
4. Repeat steps #1 thru #3 to preset up to 10 FM stations.
5. To recall one of the preset stations already programmed,
tap the M+ button repeatedly until you reach the desired
preset number/radio station.
SLEEP TIMER OPERATION
The sleep timer allows you to turn the unit off after a designated
time has elapsed.
1. While listening to the radio, tap the SLEEP button and sleep
time '90' (minutes) appears in the LED DISPLAY.
2. Repeatedly tap the SLEEP button to select a sleep timer of
90, 60, 30 or 15 minutes. Wait for about 10 seconds after your
selection for the unit to confirm the selection, the unit will play
for the selected length of time then turn itself 'Off'
automatically.
3. To cancel the sleep timer, repeatedly tap the SLEEP button
until you see the current time in the LED DISPLAY after last
sleep timer option (15 minutes).
4. To turn the unit 'Off' before the selected sleep time, press the
POWER ON-OFF button at any time.
E - 8