LENCO CR-16 Mode D'emploi page 6

- To check the year while the current time is displayed, tap the
YEAR-MONTH-DAY button once. The LED DISPLAY will
change to the year display for 5 seconds and then revert to the
current time automatically.
- To check the date while the current time is displayed, tap the
YEAR-MONTH-DAY button twice. The LED DISPLAY will
change to the date display for 5 seconds and then revert to the
current time automatically.
- During the time set, if no button is being pressed within 10
seconds, the current display time will be automatically stored.
- Make sure the hour is set so that the PM indicator is displayed
correctly for afternoon/night times.
ALARM SETTING
SETTING THE ALARMS (ALARM 1 and ALARM 2)
You can select either a Beeper Alarm or the FM Radio as the
alarm source. Be sure to observe the PM indicator when setting
the alarm to make sure the alarm time is set correctly for AM or
PM. If the PM Indicator is 'On', the alarm time will be afternoon/
night time. The setting sequence for ALARM 1 is as follows:
Normal Time → AL1 Hour → AL1 Minute → AL1 Weekday → AL1
Beeper → AL1 Radio → AL1 final radio volume → Normal Time
1. In standby mode, tap the ALARM 1 (or ALARM 2) button to
show the preset alarm time.
2. Press and hold the ALARM 1 (or ALARM 2) button again for
about 2 seconds until the Hour Indicator on the LED DISPLAY
flashes. Press the << or >> button to obtain the desired Alarm
Hour.
3. Tap the ALARM 1 (or ALARM 2) button again to advance
to the Minute Indicator. Press the << or >> button to obtain the
desired Alarm Minutes.
4. Tap the ALARM 1 (or ALARM 2) button again to advance to
the Weekday Indicator.
Press the << or >> button to select the desired Alarm Weekday
mode as follows:
1-5 : Monday to Friday
1-7 : Whole week
E - 5