LENCO CR-16 Mode D'emploi page 11

sharpness and angle.
- Press PROJECTION 180º FLIP button to flip the projected
image.
- To deactivate projection function, simply press PROJECTION
ON/OFF button. The projection lens goes off.
RESETTING THE UNIT
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller
to shut down automatically. If this occurs, disconnect the AC
POWER CORD from the wall and remove the backup battery from
the compartment. Wait at least 3 minutes, and reinsert the battery
for the back-up, and reattach the AC Cord to the wall. The unit
is now reset, so you will need to setup the unit time and alarms
again.
SPECIFICATIONS
Frequency :
Battery backup :
Power source :
Projection distance: ≤ approx. 90 to 270cm
FM 87.5 – 108 MHz
1 x 3V CR2032 flat lithium battery (not
included)
AC 230V ~ 50Hz, 5W
E - 10