LENCO CR-16 Mode D'emploi page 5

on! If the reception cannot be automatically adjusted after 10
minutes in spite of the alignment of the integrated antenna, the
reception in the respective location is too weak. In this case, set
the time manually or change location.
POWER ON/STANDBY
1. In standby mode, tap the POWER ON-OFF button once to turn
on the unit.
2. Press the POWER ON-OFF button once to return the unit to
standby mode.
CALENDAR AND TIME MANUAL SETTING
SETTING THE CALENDAR AND TIME
When the device is searching for a radio signal, it is not possible
to adjust the time manually.
1. Press the POWER ON-OFF button to switch the device into
standby mode.
2. Press and hold the SNOOZE/SLEEP/DIMMER button. The
"RCC ANTENNA TOWER Indicator" symbol starts flashing in
the display.
3. Press and hold the SNOOZE/SLEEP/DIMMER button for
about 2 seconds. The "RCC ANTENNA TOWER Indicator"
symbol disappears from the display.
4. Press and hold the CLK.ADJ. button for about 2 seconds to
enter the calendar/time set mode.
5. The year indicator will flash on the LED DISPLAY for up to 30
seconds prompting for a new entry.
6. While the display is flashing, repeatedly tap the << or >>
button to adjust to the correct year. Press and hold the << or
>> button for faster scanning backward or forward. Tap the
CLK.ADJ. button to confirm.
7. Repeat steps #2 to #3 to adjust the month, day, time format,
current hour and finally the current minutes in the same way.
Notes:
- The display sequence in calendar/time set mode will be as
follows:
Year → Month → Date → 12/24 Hour Time Format → Real
Time Hour → Real Time Min → Normal Time
E - 4