LENCO CR-16 Mode D'emploi page 3

PM Indicator
ALARM 1 Indicator
POWER CONNECTION
This product operates on AC230V~ 50Hz power supply. Plug the
AC power cord into a household outlet AC source.
INSTALLING/REPLACING THE BACK-UP BATTERY
This unit is equipped with a battery back-up system, requiring one
DC3V CR2032 lithium battery (not included) to maintain the time/
calendar settings and radio presets during AC power outage.
1. Unscrew and remove the BATTERY COMPARTMENT
COVER.
2. Install one fresh CR2032 lithium battery into the battery
compartment following the polarity diagram on the BATTERY
COMPARTMENT COVER. Use only the specified size and
type of battery.
3. Replace the BATTERY COMPARTMENT COVER and tighten
its screw.
Note: The unit will operate without a battery installed but your time
& alarm setting and radio presets will be lost and will have to be
reset in the event of power interruption or failure.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may
damage the unit and void the warranty. For best performance and
longer operating time, we recommend the use of a good quality
battery.
LED DISPLAY
TIME Indicator
E - 2
MHz Indicator
RCC ANTENNA
TOWER Indicator
ALARM 2 Indicator