LENCO CR-16 Mode D'emploi page 7

6-7 : Saturday & Sunday
1-1 : One day of week (you need to further select 1 for
Monday, 2 for Tuesday and so on)
5. Tap the ALARM 1 (or ALARM 2) button again to advance to
select the Alarm source between Beeper or Radio.
Notes:
- When the Beeper alarm begins, it will sound at a lower
beeping rate and gradually increase to the normal rate within
30 seconds.
- If you want to choose the radio as the alarm source, you need
to set the radio to your desired radio station in radio mode first.
- After selecting the Radio as the alarm source during alarm
setting, you need to select FM radio and the preset alarm
volume level (up to maximum level 15). When the radio is
turned 'On' at the preset alarm time, the radio will begin to
sound at a low volume and gradually increases to the preset
volume level.
Note: it is not possible to adjust the volume level during the radio
alarm. If volume adjustment is needed, you must turn 'Off' the
radio first, and then turn it 'On' again using the POWER ON-OFF
button. The alarm will also be stopped immediately.
6. Press the ALARM 1 (or ALARM 2) button to finish setting and
exit to normal time display.
7. To disable ALARM 1 (or ALARM 2) from automatically
sounding on the upcoming days, press and hold the ALARM
1 (or ALARM 2) button for about 2 seconds, the corresponding
ALARM 1 (or ALARM 2) INDICATOR will go off.
8. To resume ALARM 1 (or ALARM 2) from automatically
sounding on the upcoming days, press and hold the ALARM
1 (or ALARM 2) button for about 2 seconds, the corresponding
ALARM 1 (or ALARM 2) INDICATOR will turn on and the alarm
will sound the following day at the set time.
TURNING OFF THE ALARM
When the preset alarm time is reached, the ALARM 1 (or ALARM
2) INDICATOR will flash on the LED DISPLAY and the beeper
alarm or radio will sound for 30 minutes unless interrupted
by pressing SNOOZE. To stop the alarm immediately, tap the
corresponding ALARM 1 (or ALARM 2) button or POWER ON-
E - 6