cecotec CONGA 3890 ULTRA Manuel D'instructions page 21

ENGLISH
return to the charging base direct and automatically. If the robot has not started cleaning
from the charging base, it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes: Turbo/Normal/Eco.
Back home mode
Fig. 16.
Press the back home button on the remote control in order to send the robot to the charging
base. This function can be activated during any other cleaning cycle and the robot will
automatically return to the charging base and stop the cleaning process. The robot will take
the shortest route back to the charging base thanks to its map memorizing and the smart
back home function.
When a cleaning cycle has been completed or the robot's battery is low, thanks to its Total
Surface 2.0 technology, the robot will also return to the charging base to avoid running out of
battery. Once the robot has recharged, it will resume cleaning from the point it has stopped.
Notes:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the robot can get to the
charging base without problems.
Pause
While the robot is operating, press the power button on the App, the remote control or on the
robot to pause it and press the same button again to resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press the power button on the App, the remote control or on the robot to start it up again.
Warnings:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a time. Make sure to
schedule it either from the Smartphone App or from the remote control.
The robot is provided with a schedule function in order to provide a maximum-efficiency cleaning.
The time settings and the cleaning scheduling must be carried out from the remote control.
Once the robot has been scheduled, it will automatically carry out the cleaning cycles every
scheduled day.
Note: Make sure the robot is activated and that the light indicator is lighted before scheduling
any cleaning or setting time.
38
3890
Current time
Fig. 17.
Hold down the time button for 3 seconds. The first 2 digits, indicating the hour, will start
blinking.
Use the up and down direction buttons to set the current time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Fig. 18.
Press the time button to save the settings.
Fig. 19.
Cleaning scheduling
Fig. 20.
Long press the schedule button for 3 seconds. The first 2 digits, indicating the hour, will start
blinking.
Use the up and down direction buttons to set the schedule time. Then, use the left and right
buttons to switch from hours to minutes and repeat the before step.
Fig. 21.
Press the schedule button again to save the settings.
To cancel the scheduled cleaning, follow the below steps:
Set the clock on the remote control at 00:00 a.m. and save it.
Fig. 22.
Switch the robot off for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.
Note: When the remote control's batteries are replaced, the clock and schedule times must
be set again.
Light indicator:
Operating: Steady blue light.
Low power: Orange light blinks slowly.
Charging: Orange light oscillates.
Network configuration: Blue light blinks slowly.
Start-up/firmware update: Blue light oscillates.
Error: Red light flashes quickly.
5. MOBILE APP AND WI-FI CONNECTION
In order to access all the robot's functions from wherever you are, it is suggested to
download the Conga 3000 App. You will be able to control the robot in the most efficient way,
enjoying the excellence of cleaning.
ENGLISH
39
3890