cecotec CONGA 3890 ULTRA Manuel D'instructions page 20

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

ENGLISH

charged again, it resumes the cleaning cycle from the point it has stopped until it maps the

whole surface. The robot keeps on mapping constantly, therefore it adapts independently to

each house's features and continuously improves previous maps.

4. OPERATION

Once the robot's light indicator changes from oscillating orange to steady blue, the battery is

fully charged and the robot is ready to operate.

The robot cannot operate with low battery.

Recommendations: Remove all cables and obstacles from the floor before operating the

robot in order to avoid accidents and damage.

5.1. Robot buttons

Fig. 12.

Auto mode

Press the power button on the robot for it to start cleaning automatically, first a cleaning

cycle in Edge mode and then another cycle in and organized zigzag motion, recognizing which

areas it has cleaned and which ones it has not. The robot will automatically plan the cleaning

route as it is cleaning. If during this mode the robot is controlled manually, the robot will

calculate the route again and could go through previously cleaned areas. In order to ensure

efficient cleaning, do not operate it manually during auto mode cleaning.

Thanks to its Total Surface 2.0 technology, if the battery is low during the cleaning cycle, the

robot will smartly return to the charging base automatically and, once it is fully charged, it

will resume the cleaning process from the same point, offering a high-efficiency cleaning.

During cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning

route (this stop will vary depending on the house conditions).

Note: The robot cleans in an organized way and per 4x4 m squared areas, therefore it might

leave the room where it is cleaning to finish off the delimited area. Do not worry, the robot

will clean all the accessible surface.

Back home mode

Press the back home button on the robot in order to send it to the charging base. This mode

can be activated during any other cleaning cycle and the robot will stop cleaning and return

to the charging automatically.

The robot will take the shortest route back to the charging base thanks to its map

memorizing and the smart back home function. When a cleaning cycle has been completed or

the robot's battery is low, the robot will also return to the charging base to avoid running out

of battery.

Recommendation: Remove the Wet & dry tank during charging.

3890

5.2. Remote control

Fig. 13.

Schedule

Power levels (Turbo/Normal/Eco)

Back home

Clock

Manual control

On/Pause

Edge mode

The following modes and operations can be activated from the remote control.

Modes

The first time the robot is operated, it will map and save the whole house's map by means of

its laser before starting the cleaning cycle. Use the robot in Auto mode and Eco power level,

this way you will ensure the robot memorizes the full map.

Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is activated.

If not, press any button on the remote control to wake it up.

Auto mode

Fig. 14.