Vogel KFA Instructions De Service page 73

Display Function
Monitoring OFF
Cycle Switch
Pressure Switch
Fault: Low Level
Fault: Cycle Switch
Operation Hour Meter
Fault Hour Meter
Block operation
The monitoring function PS and CS is
deactivated
Cycle switch monitoring is active
Not to be used for KFA/KFAS units!
The minimum level in the reservoir has been
reached
No signal from cycle switch during pump
running time
The subsequently displayed values are the operating hours of the control unit.
The subsequently displayed values are the fault hours. Time during which the control unit or the
machine has been operated in the FAULT mode.
Signal from cycle switch missing. Contrary to normal operation, the control unit is still in the monitoring
mode. If the fault continues to exist for 3 pump running periods, a fault message is displayed.
Description
•
No system monitoring
•
The cycle switch is monitored for signal
transmission during the pump running time
CONTACT.
•
The control unit is in the FAULT mode.
•
The sequence of operations is stopped.
•
The control unit is in the FAULT mode.
•
The sequence of operations is stopped.
Page 24
Contents Chapter
5
Operating Instructions KFA, KFAS