Kfas1-M, Kfas1-M-W; Kfas1-M-Z, Kfas1-M-W-Z; External Cycle Switch - Vogel KFA Instructions De Service

4.3 KFAS1-M, KFAS1-M-W

Supply voltage 24 V DC
Mind voltage values specified on
nameplate and in section 4.1 !
X 1 Electrical connection: Pin-and-socket
connector according to DIN 43650-A.
Applies to all KFAS1-M units !
KFAS1-M
3
KFAS1-M-W
X1
KFAS1-M-Z
Connector
KFAS1-M-W-Z
1 2
X1
F 3A
L+
M (OV, GND)
X1 Pin-and-socket connector supply voltage
L+ + potential supply voltage
M - potential supply voltage
5) PIN without internal connection
SL2 Signal lamp „Fault"
KFAS1-M
The KFAS1-M unit is provided only with the pin-
and-socket connector X1.
No internal level monitoring !
No external cycle switch monitoring !
KFAS1-M-W
The KFAS1-M unit is provided only with the pin-
and-socket connector X1.
With internal level monitoring.
A built-in level monitoring facility is always active.
When the level drops below the „min" mark, the
sequence of operations is stopped, and a fault
message
No external cycle switch monitoring !
3
5)
SL2
2,4 W
appears in the display.
Page 19
Contents Chapter
Operating Instructions KFA, KFAS

4.4 KFAS1-M-Z, KFAS1-M-W-Z

These units are provided with the pin-and-socket
connector X1 for the voltage supply and with a
circular pin-and-socket connector M12x1 for con-
nection of an external cycle switch (X3).
3
Connector
4
1
Socket
Figure 13 Pin-and-socket connectors
KFAS1-M-W-Z
KFAS1-M-Z
No internal level monitoring. For connection of an
external cycle switch, see page 20.
KFAS1-M-W-Z
With internal level monitoring, see KFAS1-M-W
section 4.3. For connection of an external cycle
switch, see page 20.
4
X1
3
X3
2