Operating Instructions - Stihl MS 201 TC-M Notice D'emploi

English
Pull the hand guard back towards
N
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
At very low outside temperatures
Change over to winter operation if
N
necessary – see "Winter Operation".
Stopping the Engine
Move the Master Control lever in the
N
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
If engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
22
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Hold the saw on the ground.
N
Push the Master Control lever as far
N
as stop in direction of STOP or †
and hold it there.
WARNING
An ignition spark may occur if the Master
Control lever is not held against STOP
or †.
Operate the rewind starter several
N
times.
Release the Master Control lever – it
N
springs back to the run position F.
Install the spark plug – see "Spark
N
Plug".
Hold and start your saw as
N
described.

Operating Instructions

During the break-in period
A factory new machine should not be run
at high revs (full throttle off load) for the
first three tank fillings. This avoids
unnecessarily high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
shortblock are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During work
NOTICE
Open the throttle only when the chain
brake is off. Running the engine at high
revs with the chain brake engaged
(chain locked) will quickly damage the
engine and chain drive (clutch, chain
brake).
Check chain tension frequently
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period.
Chain cold
Tension is correct when the chain fits
snugly against the underside of the bar
but can still be pulled along the bar by
hand. Retension if necessary – see
"Tensioning the Saw Chain".
MS 201 TC-M