Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MN007942A01-AB
Chapter 10: Initiating Radio Enable
Chapter 10
Initiating Radio Enable
Prerequisites:In One Touch Access, set the <required call type> to Radio ENABLE.
Procedure:
1 Select the channel with the subscriber ID that you want to enable transmission from.
2 Press the programmed One Touch Access button.
When your radio transmits enable signal, the red LED illuminates.
NOTE: Your radio may transmit enable signal up to three times.
If initiating radio enable is successful, your radio shows the following indications:
•
A positive indicator tone sounds.
•
The green LED blinks once.
If initiating radio enable is unsuccessful, a negative indicator tone sounds.
The receiving radio restarts.
28
Publicité
Chapitres
Table des Matières
