shark Spartan GT Carbon Manuel D'utilisation page 7

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

WARNING! Never use the loop as the sole
means for closing the chin strap. To ensure
adequate tightening, the chin strap must be
inserted into the double-D buckles in strict
accordance with the instructions. Any misuse of
the chin strap may result in your helmet coming
off during an accident, thereby leaving your
head exposed without any protection. Try pulling
on the chin strap with your fingers. If the strap
loosens even to the slightest extent, you haven't
DOUBLE-D RING
1. Slide the longest part of the chin strap through the two
rings, while verifying that the comfort pad is correctly
positioned between the strap and your neck (see Figure A).
2. Form a loop with the end of the chin strap around the
outer ring and reinsert it into the inner ring (see Figure B).
3. Pull on the strap end until the chin strap is taut. The chin
C
properly closed the chin strap in the double-D
buckles. If so, repeat the steps described opposite.
Never ride with the chin strap open, inadequately
closed or poorly positioned. Even if the cheek
pads give the impression that the helmet
is providing secure support, it would still
come off during an accident, thus leaving
your head exposed without any protection.
Should you have any doubts concerning
the
helmet
closing
the helmet. Ask your retailer for advice.
strap must be positioned against the neck and not under
the chin. It must be as tight as possible without causing
pain or obstructing breathing (see Figure C).
4. Slide the free end of the strap into the plastic loop in
order to prevent any flapping of the strap in the wind
(see Figure D).
CHIN STRAP
B
system,
don't
use
D
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Spartan gt

Table des Matières