shark Spartan GT Carbon Manuel D'utilisation page 5

adjusting the helmet. Should this not be
the case, the selected helmet is too big,
try the next smaller size (see Figure B).
3. With the chin strap fastened, grab the
back of the helmet by its base and try
to remove it from your head by a rota-
tional movement. Next, try to remove
the helmet by grabbing it at the base of
the chin guard. You must perform these
movements in expending a sufficient
amount of effort. If the helmet starts to
loosen, then the selected helmet is too
big, hence try the next smaller size.
4. Lean your head forward as much as
possible. The base of the chin guard must
not touch your chest (see Figure C).
5. Now lean your head backward as
much as possible. The base of the helmet
must not touch your back (see Figure D).
Avoid bunching or attaching your hair in-
side the helmet.
Do not place anything in or on your hair
inside the helmet. Avoid adding anything
inside the helmet to adjust its position on
C
A HELMET IN YOUR SIZE
your head.
For questions regarding choosing the
right helmet size, please seek advice
from your retailer.
Each of these steps needs to be repeated
throughout the helmet use life since
the cushiony foam may alter over time.
Should the foam no longer be sufficient-
ly thick when wearing the helmet, it will
need to be replaced.
WARNING!
helmet without first verifying, in
accordance with instructions laid out in
this manual, that it fits the other person
snugly.
WARNING! If in following these
instructions, the helmet you iden-
tify is not perfectly suitable, DO NOT
WEAR IT. Instead, choose a different size
or model.
Never lend your
D
5