shark Spartan GT Carbon Manuel D'utilisation page 16

VISOR SCREEN
INSTALLATION OF THE SCREEN
1- Introduce the visor into its slot in a slight-
ly inclined position. Fully insert the visor into
its slot and keep pushing until it «clicks».
2- Realign the circle on the visor with that
on the shell, just like during removal. Now
press and pivot the locking pin backward in
order to lock the visor. Repeat this step on
the other side. Close the visor.
To adjust visor hardness and friction, use
an Allen wrench. Screw tighter to harden,
unscrew to relax.
WARNING! If you are not sure that
16
you properly replaced the visor, do not use the
helmet. The visor could suddenly and without
warning become detached from the helmet
while riding, causing you to lose control of your
motorcycle, resulting in an accident, personal
injury, or death.Contact your retailer for any as-
sistance or advice. Do not ride with an open
visor and do not try to open or adjust the visor
while riding. The visor could suddenly and wit-
hout warning become detached from the helmet,
leaving your eyes and face unprotected. In ad-
dition, your head could be pulled to the side,
causing you to lose control of your motorcycle.
These events could cause you to lose control of
your motorcycle, resulting in an accident, personal
injury or death.
SUN VISOR
1 - Your helmet has been equipped with an
internal sun visor. To use this accessory, redirect
the arrow toward the front. To cover the sun visor,
reposition the arrow toward the back.
NEVER ride with the sun shield as eye protection.
You must always ride with the visor in the lowered
position, as described in the previous section.