Adjusting Your Machine; Mitre Cutting Adjustment - Jet ELITE EHB-270DGSVIP Mode D'emploi

8. Set the saw arm descend rate via valve (O).
9. Turn operating mode (M) to "Auto".
10. Press cycle start button (E) to start operation.
11. At the end of cutting, the hydraulic vise will open
automatically.
12. The saw arm will return to the bow's maximum set
height.
13. Now the machine is ready for the next operation.
CAUTION:
Be sure to stand in a safe location while operating the
machine.
In general, start the cutting, by slightly turning hydraulic flow
regulation valve (O) clockwise from 1 to 2 to control the saw
arm descent rate.
If the arm descends too quickly, turn hydraulic valve (O)
counter-clockwise.
A saw arm dropping too quickly can cause the blade to stall
and the machine to shut off.
In case, push the emergency stop button (I). It immediately
stops all machine functions.
During the operation cycle, the hydraulic vise will
automatically close on the work piece for a distance up to
8mm.
The hydraulic vise will open maximum 8mm on the end of
cycle and be ready for the next operation.
Therefore it is not necessary to manually lock down the vise
jaws by hand. Keep a gap of 4~5mm between the jaws and the
work piece.
In case of Emergency or problem, press the emergency stop
button (I). It immediately stops all machine functions.
To release the emergency stop button, rotate it clock-wise.
The hydraulic pump will automatically shut-off after 10
minutes of non-operation.

8.0 Adjusting Your Machine

8.1 Mitre Cutting Adjustment

Mitres between 60° (R) and 45° (L) can be adjusted.
Adjust saw bow as below steps:
1. Switch On Main power (A, Fig 7-1).
2. Press button (C) to start the hydraulic pump.
3. Use switch (M) to select manual mode
4. Use switch (J) to raise the saw bow.
6. Switch off Main power (A).
7. Un-clamp saw bow, by rotating the lock lever
(S, Fig 8-1) to the left.
Figure 8-1: Mitre Cutting Adjustment
9. Rotate the saw bow to the desired angle by following the
scale (U, Fig 8-2).
16