Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Laser class 2
<1mW, 400-700nm
Laser power supply
2 batteries AAA
4.2 Noise emission
(Inspection tolerance 4 dB)
Acoustic power level
(according to EN ISO 3746):
Idling
LwA 101,5 dB(A)
Acoustic pressure level
(according to EN ISO 11202):
Idling
LpA 88,7 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
This information is intended to allow
the user to make a better estimation
of the hazards and risks involved.
4.3 Content of delivery
1 mitre saw
2 table extension pieces
1 length gauge
1 workpiece clamp
1 dust extraction bag
1 sawblade 40 tooth
1 spanner
Operating manual
Spare parts list
4.4 Mitre saw description
Fig 1
A....Unlock button
B....Motor housing
C....Workpiece fence
D....Length gauge
E, L..Table extension pieces
F....Machine table
G....Dust bag
H....Sawblade
I.....Bevel lock knob
J....Protective cover for blade
K....Workpiece clamp
Fig 2
M....Handgrip with switch
N....Spindle lock button
O....Cutting head lock button
P....Bevel scale
R....Bevel lock knob
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate
in closed rooms and must be placed
stable on firm and levelled surface.
The machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice any transport damage
while unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
a mild solvent.
Mounting the table extensions
Mount the length gauge (B, Fig 3) to
the left or right table extension.
Fig 3
Use the clamping pieces (A) to lock
the table extensions (C) in place.
Mounting the dust bag
Use the dust bag (G, Fig 1) to collect
the dust emissions. You can slide the
dust bag onto the dust port on the
rear of the machine.
5
The dust port is also suitable for the
connecting to a dust collector.
Unlocking the cutting head
The mitre saw is supplied with the
cutting head in locked position. The
cutting head lock button (O, Fig 2)
can be pulled out by pushing the
cutting head down at the same time.
Allow the cutting head to slowly rise.
The cutting head should be relocked
for transportation.
5.3 Mains connection
Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine
licence plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked
H05VV-F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.
5.4 Starting operation
You can start the machine by
pressing the trigger on the handle
with your fingers.
To stop the saw release the trigger.
6. Machine operation
Correct working position:
In front of the machine standing in the
direction of cutting.
Workpiece handling:
Support long workpieces with helping
roller stands.
During cutting operation the
workpiece must be locked against the
fence with the workpiece clamp.
Do not perform any operation
freehand.
Operating hints:
Always observe the safety
instructions and adhere to the
current regulations.
Ensure that the saw blade protective
cover is in the correct position before
you start sawing.
The mitre saw is switched on by
means of the trigger button that is
situated on the inside of the handgrip
(M, Fig 2).
Publicité
Chapitres
Table des Matières
