Télécharger Imprimer la page

Spektrum STX3 Notice page 4

Masquer les pouces Voir aussi pour STX3:

Publicité

Les langues disponibles

Les langues disponibles

EN
End Point Adjustments
Steering End Points:
1. Enter programming mode by turning the wheel fully right and
powering on the transmitter. The right LED will fl ash rapidly.
Release the wheel.
2. Fully turn and hold the wheel to the left (counterclockwise).
While holding the wheel fully left, press the CH3 push buttons
to adjust the proper left end point position.
3. Fully turn and hold the wheel to the right (clockwise).While
holding the wheel fully right, press the CH3 push buttons to
adjust the proper right end point position.
4. Release the steering wheel.
5. Power off the transmitter to save the settings.
2.4GHz TROUBLESHOOTING GUIDE
Problem
The system will not
connect
The receiver goes into
failsafe mode a short
distance away from the
transmitter
The receiver quits
responding during
operation
1 YEAR LIMITED WARRANTY
What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the original
purchaser that the product purchased (the "Product") will be
free from defects in materials and workmanship for a period
of 1 year from the date of purchase.
What is Not Covered
This warranty is not transferable and does not cover (i)
cosmetic damage, (ii) damage due to acts of God, accident,
misuse, abuse, negligence, commercial use, or due to
improper use, installation, operation or maintenance, (iii)
modifi cation of or to any part of the Product, (iv) attempted
service by anyone other than a Horizon Hobby authorized
service center, (v) Product not purchased from an authorized
Horizon dealer, (vi) Product not compliant with applicable
technical regulations, or (vii) use that violates any applicable
laws, rules, or regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON
MAKES NO OTHER WARRANTY OR REPRESENTATION, AND
HEREBY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES,
INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE HAVE
DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE
REQUIREMENTS OF THE PURCHASER'S INTENDED USE.
4
Possible Cause
Your transmitter and receiver are too close together Move transmitter 1 to 3 meters from receiver
You are around metal objects
The model selected is not the model bound to
Your transmitter was accidentally put into bind
mode and is no longer bound to your receiver
Check the receiver antenna to be sure it is not
cut or damaged
Inadequate battery voltage
Loose or damaged wires or connectors between
battery and receiver
Throttle End Points:
1. Enter programming mode by turning the wheel fully right and
powering on the transmitter. The right LED will fl ash rapidly.
Release the wheel.
2. Pull the throttle trigger fully back. While holding the throttle
trigger, press the CH3 push buttons to adjust the proper full
throttle position.
3. Push the throttle trigger fully forward to set the maximum
brake end point. While holding the throttle trigger, press the
CH3 push buttons to adjust the proper full brake position.
4. Release the throttle trigger.
5. Power off the transmitter to save the settings.
Move to an area with less metal
Check model selected and ensure you are bound
to that model
Rebind your transmitter and receiver
Replace the receiver or contact Horizon Product
Support
Make sure your receiver antenna is in an antenna
tube and is above the vehicle
Charge batteries. Spektrum receivers require at
least 3.5V to operate. An inadequate power supply
can allow voltage to momentarily drop below 3.5V
and cause the receiver to brown out and reconnect
Check the wires and connection between the battery
and receiver. Repair or replace wires and/or connectors
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and exclusive
remedy shall be that Horizon will, at its option, either (i)
service, or (ii) replace, any Product determined by Horizon
to be defective. Horizon reserves the right to inspect any
and all Product(s) involved in a warranty claim. Service or
replacement decisions are at the sole discretion of Horizon.
Proof of purchase is required for all warranty claims. SERVICE
OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS
THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY.
Limitation of Liability
HORIZON SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT,
INCIDENTAL OR CONSEQUENTIAL DAMAGES, LOSS OF
PROFITS OR PRODUCTION OR COMMERCIAL LOSS IN ANY
WAY, REGARDLESS OF WHETHER SUCH CLAIM IS BASED IN
CONTRACT, WARRANTY, TORT, NEGLIGENCE, STRICT LIABILITY
OR ANY OTHER THEORY OF LIABILITY, EVEN IF HORIZON HAS
BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Further, in no event shall the liability of Horizon exceed the
individual price of the Product on which liability is asserted.
As Horizon has no control over use, setup, fi nal assembly,
modifi cation or misuse, no liability shall be assumed nor
accepted for any resulting damage or injury. By the act of use,
setup or assembly, the user accepts all resulting liability. If you
as the purchaser or user are not prepared to accept the liability
associated with the use of the Product, purchaser is advised to
return the Product immediately in new and unused condition to
the place of purchase.
Solution
SPEKTRUM STX3 USER GUIDE

Publicité

loading