Kospel WW Mode D'emploi page 29

Connection to the water
system
Connection to the water system must be performed according to binding norms of
hydraulic installation. The cylinder is a pressure appliance designed for connection
to the water supply system where the water pressure doesn't exceed 0,6 MPa. If
the water pressure exceeds 0,6 MPa the pressure reducing valve before cylinder
must be fitted.
Please follow the water connection instructions below:
- Install the T-connection with 6 bar safety valve and the drain valve to the
inlet fitting of cold water [1]. It's forbidden to install a cut-off valve (or any flow
reducer) between tank and the safety valve and on it's outlet. The safety valve
must be installed in that place to let you quickly see the outgoing water.
- Install the cylinder equipped with the safety valve to the water system
- Install the cut-off valve on cold water supply pipe.
Hot water outlet pipe must be connected to the ¾" fitting, which is located in the
upper part of the unit.
Each cylinder is equipped with ¾" fitting for domestic hot water circulation connection.
PL;DE;FR;GB-019_f.530
GB
29