Fein ASCM12 Mode D'emploi page 18

OBJ_BUCH-0000000367-001.book Page 18 Thursday, February 14, 2019 2:50 PM
en
18
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Setting the torque (figure 9).
Adjust the torque only when the machine is at
a complete stop.
The tightening torque also depends on the
force with which the power tool is pressed
against the screw.
– Low torque: Small screws
– High torque: Large screws
Determine the torque setting with which the
screws are screwed flush into the material by
practical testing.
Fig. 9
-
+
Torque setting