Fein ASCM12 Mode D'emploi page 17

OBJ_BUCH-0000000367-001.book Page 17 Thursday, February 14, 2019 2:50 PM
Changing the tool.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Mounting application tools
(ABSU12 (**), ASCM12 (**))
(figure 6).
Open the keyless drill chuck.
Afterwards, insert the desired application
tool.
Tighten the keyless drill chuck.
Mounting application tools
(ASCM12 (**)) (figure 7).
Insert the application tool.
Mounting application tools
(ABSU12W4 (**)) (figure 8).
Slide the sleeve frontwards.
Afterwards, insert the desired application
tool.
Fig. 6
Drill chuck
2.
Fig. 7
Fig. 8
1.
2.
en
17
3.
1.