DeFelsko PosiTector SHD Notice D'instruction page 8

Test Time
The PosiTector SHD has an on-screen timer to measure the
hardness of a material after a given period of time as defined by
international standards, typically 1, 3 or 15 seconds.
Use the and
taking a reading, the timer starts automatically once the presser
foot is on the surface and the ▼ symbol appears on the display.
Auto Ign. 20/90
According to most international standards, readings below 20
and above 90 are not considered reliable. When enabled,
measurement results outside 20/90 will emit a low tone and will
not be included in Memory or Statistics.
NOTE:
If values above 90 Shore A are measured, the
PosiTector SHD D probe should be used. If values below 20
Shore D are measured, use the PosiTector SHD A probe.
Sound
Adjusts the volume of built-in speaker (Off, Low, Medium, High).
Flip Lock
Disables the Auto Rotate feature by locking the display in its
current orientation.
Touch
Allows the touch screen functionality to be disabled. All gage
functions can also be controlled using the navigation buttons.
Set Clock
All measurements are date and time stamped (24-hour format)
when stored into memory. It is therefore important to set the
correct date and time. Use the
value, and the
and time setting can also be viewed at the top of the main menu.
buttons to adjust the test duration. When
(Auto Ignore)
and buttons to adjust it. The current date
6
and buttons to select a