DeFelsko PosiTector SHD Notice D'instruction page 7

Reset
Reset (menu reset) restores factory settings and returns the
Gage to a known condition. The following occurs:
- All batches, stored measurements, batch names and screen
captures are erased.
- Calibration adjustments are returned to factory settings.
- Menu settings are returned to the following:
Memory = OFF
Auto Sub-Batch = OFF
Statistics = OFF
Hi Lo Alarm = OFF
Hi Res = OFF
Auto Dim = ON
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the
until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition. It
performs the same function as a menu Reset with the addition of:
- Bluetooth Pairing info is cleared.
- Menu settings are returned to the following status:
Bluetooth = OFF
Sound = Medium
Backlight = Normal
Flip Display = OFF
Touch = ON
NOTE:
Date, Time and WiFi settings are not affected by either Reset.
Cont. Reading
When enabled, the Gage will continuously display probe readings.
Ideal when a test timer is not required or when performing a
calibration verification. Cont. Reading is not available when
Memory, Statistics, or HiLo Alarm modes are enabled.
Setup Menu
Setup Menu
Bluetooth Classic = OFF
WiFi & Access Point = OFF
Keyboard & Stream = OFF
Auto Ignore 20/90 = OFF
Continuous Reading = OFF
appears.
(Continuous Reading)
5
and
Test Time = 1 second
Auto Sync .net = ON
USB Drive= ON
Language = English
Battery Type = Alkaline
buttons