DeFelsko PosiTector SHD Notice D'instruction page 14

Shore hardness durometer

Masquer les pouces Voir aussi pour PosiTector SHD:

Les langues disponibles

Before returning the Gage for service...

1.Install new or newly recharged batteries in the proper

alignment as shown within battery compartment.

2.Examine the indentor tip and presser foot for dirt or damage.

3.Perform a Hard Reset. (pg. 5)

4.Attempt a measurement on the supplied test block.

(see Verification, pg. 3)

5. If issue is not resolved, Update your PosiTector gage body

(pg. 11) and re-attempt measurements.

IMPORTANT:

If these steps do not resolve the issue and the Gage must be

returned for service, please follow the instructions provided at

www.defelsko.com/service.

Limited Warranty, Sole Remedy

DeFelsko's sole warranty, remedy, and liability are the express

limited warranty, remedy, and limited liability that are set forth on

its website: www.defelsko.com/terms

or part, by any means, without written permission from DeFelsko Corporation.

DeFelsko, PosiTector, and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and

in other countries. Other brand or product names are trademarks or registered trademarks of their

respective holders.

Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not

responsible for printing or clerical errors.

Returning for Service

and Limited Liability

www.defelsko.com