Jay J3 Carbon Manuel D'utilisation page 15

ENGLISH
VANITY FLAP INSTALLATION
1. Lift upper flap of J3 Carbon Back Cover (Fig. 22)
2. Match hook to loop and attach Vanity Flap to the back
of the J3 Carbon Back Cover (Fig. 23). Reposition upper
flap of cover to sandwich the Vanity Flap between the
flaps the upper and lower flaps (Fig. 24).
3. Remove Seat Back from wheelchair and sandwich
"tail" of Vanity Flap between wheelchair support surface
and Seat Back (Fig 25).
4. Adjust Vanity Flap as necessary by moving the tail in
or out from under the Seat Back. If necessary the
upper part of the vanity flap can be moved up or down
on the Seat Back also.
5. Insert Hook & Loop Wrap ties through the appropriate
grommets on the Vanity Flap, then wrap around the
wheelchair frame and insert the leading end through the
slot end of the Wrap (Fig. 26-27). Snug up and close
outside gaps in Vanity Flap (Fig. 28).
J3 Carbon Back 127048
Fig. 22
Fig. 23
15
VANITY FLAP INSTALLATION
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Rev.C