Blade Replacement - JAC Chute Notice D'utilisation Originale

Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
8.3

Blade replacement.

(fig.8,9)
Always wear cut-resistant gloves (EN 388:2003 version B= 5) and safety footwear when replacing
blades or working in the vicinity of blades.
Having ensured that the plug on your machine has been disconnected from the mains (fig.1, n°10):
A. Remove the 6 screws securing the top rear panel.
B. Remove the two nuts securing the table clamp under the loading ramp from the inside of the
machine.
C. Remove the 4 screws securing the ramp guard and remove the ramp guard.
D. Remove the 2 Allen screws and the two thumbscrews securing the front cover and the bagger.
E. Open the cover and remove the 3 Allen screws securing the front table.
F. Remove the front table.
G. Remove screw A securing the front frame link.
H. Lay the frame down forwards. Replace the blades on the rear frame (place something to
protect yourself on the front frame blades). Remove the blade-tightening Allen screws B.
Replace the blades, checking that they locate correctly in the swing arm pins. Retighten the
blades by tightening screws B, with the blades remaining on the frame as a reference.
In order not to distort the frame and avoid the risk of dangerous breakages, only replace 1 to 3
blades at a time alternating from left to right.
Resume the procedure from point H for the front frame and refit the front frame and the cover
components. When reassembling, check that the front table slides under the rear table at the blades.
Connect your machine to the mains supply; it is now ready.
Check that your approved agent has recorded his work in your service booklet in order to maintain
your 5-year warranty cover.
English
12