Installing Propeller - Yamaha F9.9 Manuel De L'utilisateur

Maintenance
6 3
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
3. Remove the propeller, washer, and
thrust washer.
EMU30673

Installing propeller

EMU29236
Spline models
ECM00502
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1. Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
2. Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
3. Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
86
1
4 3 2
5
ZMU08167
1. Cotter pin
2. Propeller nut
3. Washer
4. Propeller
5. Thrust washer
Propeller nut tightening torque:
4.
TIP:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
[ECM01882]
specified torque, tighten the nut further to
align it with the hole.
5
17 N·m (1.73 kgf·m, 12.5 lb·ft)
Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
[ECM01892]
1
3 2
4
ZMU08169