Master Forge CBT1227L Mode D'emploi page 8

ASSEMBLY INSTRUCTIONS
4. Attach the leg supports A (J) to the bottom bowl (H)
using two sets of two M4 x 12 mm small screws
(AA), two 4.3 mm lock washers (GG) and two M4
wing nuts (DD).
Attach the leg supports B (K) to the bottom bowl
(H) using two sets of two M4 x 12 mm small screws
(AA), two 4.3 mm lock washers (GG) and two M4
wing nuts (DD).
Note: While holding lock washer (GG) and wing nut
(DD), use screwdriver to attach small screw (AA) to
wing nut (DD).
hardware used
M4 x 12 mm
aa
Small Screw
M4 Wing Nut
dd
4.3 mm Lock
GG
Washer
5. Attach the legs (L) to the leg supports (J and K).
6. Pull legs to the outside of the grill until they lock
into place.
Attach the bottom hinges (G) to the bottom bowl
(H) using two sets of two M5 x 12 mm large screws
(CC), two 5.3 mm lock washers (HH) and two M5
wing nuts (EE).
hardware used
M5 x 12 mm
CC
Large Screw
M5 Wing Nut
EE
5.3 mm Lock
hh
Washer
4
x 8
5
x 8
x 8
6
x 4
x 4
x 4
8
Lowes.com/masterforge