Korg MS-20 kit Manuel D'utilisation page 11

8. Feeding the wiring harnesses to the panel jack circuit board
Plug in the four wiring harnesses, making sure that the orientation is correct.
Assembling the bottom panel section and the front panel section
1. Attaching the front panel section to the bottom panel section with the included screws
While making sure that the shields on both sides do not bend, place the front panel on top of the bottom panel, and then slide
the front panel down against the keyboard.
Screw
2. Plugging all wiring harnesses into their connectors
Plug in the four wiring harnesses, making sure to observe the correct orientation.
After twisting the wiring harnesses of the VR circuit board and panel jack circuit board together several times, plug them into the
connectors on the rear jack circuit board.
Make sure to secure the cable from the wheel unit with clips so that it is not loose.
Caution: When making connections, hold the circuit board to firmly insert the connectors.
After twisting the wiring harnesses of the VR circuit board and
panel jack circuit board together several times, plug them into
the connectors on the rear jack circuit board.
clips
11