PNI SafeHouse HS650 Manuel Utilisateur page 4

English
General information
Burglary protection
Your alarm system has two modes of protection against burglary: Home arming
and Total arming.
Home arming (perimeter arming) only protects the perimeter, allowing you to
move freely inside the house.
Total arming protects the entire building.
Zones
The sensors paired to your alarm system will be assigned to different "zones"
(maximum 90 for wireless sensors and maximum 3 for wired sensors). For
example, the sensor on the front door of the house can be assigned to zone
01, the sensor on the window in the master bedroom in zone 02 and so on. The
zone number is displayed on the screen when an alarm or problem occurs on a
specific area.
Entry and Exit Delay
Your alarm system has been programmed with adjustable delay time that allows
you to leave the house after arming the system and disarm the system at the
entrance into the house, without triggering an alarm.
If you leave the house too late after arming the system or disarm the system
too late after entering the house, the system will trigger an alarm. Disarm the
system immediately.
The alarm and the event notifications on the phone
When an alarm is triggered, the built-in and the external siren will sound until
the system is disarmed or until the preset time interval for the siren expires. A
message will show up on the control panel screen with the area or areas where
the alarm was triggered. If set, the alarm system will call or send SMS via the
4G GSM network to the preset phone numbers (maximum 5) or will send
notification via the mobile application (Tuya Smart).
4
4