Bushnell EQUINOX Z Mode D'emploi page 6

• IMAGE BRIGHTNESS BUTTON (E)
The Image Brightness (Sun Icon) button can be used to change the digital imaging frame rate, producing a brighter image
for viewing.
• Pressing the Brightness (Sun icon) button repeatedly will cycle through the available frame rates, beginning with the default
frame rate (fastest), until the last (slowest, brightest) frame rate is reached. After that, the next press of the button returns back to
the original fastest rate. The default, fastest frame rate in Night Mode is 25fps. Pressing the Brightness button cycles through the
other frame rate settings, with the third press returning to the default again: 25fps>15fps>8fps>25fps>etc.
• In Day Mode, the default frame rate is 30fps. The frame rate cannot be changed in Day Mode, therefore the Brightness button will
have no effect. The display is a color LCD, and images will appear in color in daytime use, or in strong artificial lighting conditions.
NOTE: selecting frame rates lower than the default 25fps in Night Mode will provide a brighter image, however the decreased frame
rate may cause moving subjects to appear less smooth or stable when viewed.
(The following item is located on the bottom of the unit, under the Interface Cover Flap)
VIDEO OUTPUT JACK (F): the "live" image as seen on the unit's display is output here. Connect a male 1/8" (3.5mm) phone plug to
RCA plug cable between this jack and a video monitor or recorder to remotely view or record the image from the night vision unit.
SETUP AND BASIC OPERATION
1) LoaD BattErIES
Turn the battery compartment cover (G) in a counter-clockwise direction to remove it, and insert 4 AA batteries as indicated inside
the battery compartment. Lithium AA batteries are recommended for maximum running time, but alkaline or rechargeable NiMh
AAs may be used as well. DO NOT MIX BATTERY TYPES, OR NEW AND OLD BATTERIES. Remove the batteries if the unit will be stored
for a month or longer between uses.
2) rEMoVE LENS coVEr, aDJuSt DISpLaY (EYEpIEcE) FocuS For Your VISIoN
Press the Power button (A) to turn on the unit. A battery level icon is displayed at the top right corner of the screen. While looking
through the eyepiece (I) at the LCD display screen, rotate the eyepiece (eyecup) until the display icons or edges of the display screen
6