Bushnell EQUINOX Z Mode D'emploi page 5

CONTROLS /FUNCTIONS
POWER BUTTON (A)
The Power button (Power icon) turns the unit on or off.
• Press and hold the power button for 2 seconds to turn the unit ON
• Press and hold the power button for 2 seconds to turn the unit OFF
DIGITAL ZOOM BUTTONS (B)
The "+" and "-" buttons adjust the digital zoom power, with a range of 1.0x to 3.0x.
The displayed numbers represent a multiplication factor over the fixed optical magnification of the unit (3x).
Maximum effective magnification = 3.0 x 3.0 (9x) for the 3x30 model.
• Pressing and releasing the "+" button will gradually "zoom in" to the subject in view, by 0.1x increments
• Pressing and holding the "+" button will rapidly zoom in, until the maximum 3.0x magnification factor is reached
• Pressing and releasing the "-" button will gradually "zoom out" from the subject in view, by 0.1x increments
• Pressing and holding the "-" button will rapidly zoom out, until the digital zoom returns to the starting point of 1.0x (no digital
zoom applied, view represents the original 3x optical magnification)
IR BUTTON (C)
The "IR" button turns on/off the Infrared LED illumination (D) for low light operation, and is also used to reduce its brightness
if necessary.
• Press and release the "IR" button to turn on the infrared LED light (D) when ambient light levels are too low to provide good
viewing quality. The IR illumination will be at "100%" level when first turned on, and the display will indicate "IR2".
• Press the "IR" button a second time to reduce the IR LED brightness level when viewing subjects at close range to avoid glare or
"washout" of the image. The display will indicate "IR1".
• Press the "IR" button again to switch off the IR LED light. "IR0" will be shown at the lower center of the display. Switching off the IR
LED when ambient light levels are adequate for viewing without it (full moon, near streetlights, etc.) will extend battery life and
running time. Press the "IR" button once again to switch to DAY Mode-no IR value will be indicated.
5