Bushnell EQUINOX Z Mode D'emploi page 7

appear sharp to your eye. Remove the lens cover from the front of the objective lens (H). Note: since the Equinox Z uses digital night
vision technology (not analog "Gen 1", etc.), the unit cannot be damaged by exposure to normal indoor or outdoor light levels-however, you
should avoid pointing it directly at the sun or other very bright light sources to avoid overloading the sensor.
3) turN oN Ir LIGHt (IF NEEDED), aDJuSt oBJEctIVE LENS FocuS For SuBJEct DIStaNcE
If the image is too dark to easily view (in most building interiors, and outdoors when away from artificial lighting), press the IR button
(C) to turn on the Infrared LED light. If the image is too bright after turning on the IR light (when viewing at close range), press the IR
button again to reduce the IR light level. If the image is still too dark after turning on the IR light, try pressing the Image Brightness
button (E) once or twice to lower the frame rate of the digital sensor. If the image is not sharp, rotate the objective lens barrel (H) to
change the focus until the subject appear sharp. Do not re-adjust the Display (Eyepiece) Focus (as set in Step 2), unless the display
icons are unsharp.
OTHER OPERATIONS/FEATURES
• auto poWEr oFF
If a button has not been pressed for 10 minutes, the display screen will drop to 50% brightness level. If no button is pressed
within one minute after that, the unit will power off to extend battery life. Pressing any button quickly any time before the unit
turns off will return the screen to full brightness level and reset the auto off countdown process, without changing any other
settings.
• IcoN oVErLaY oN/oFF
The user has the option to control how the icons are displayed on the LCD screen. Normally, when any button is first pressed, ALL
icons are displayed for 5 seconds, but no change to the unit's settings is made (the IR button is an exception-the IR light turns
on at the first press of "IR"). If the same button is pressed again, the button performs its function, and the display icons remain
visible for 10 seconds after the last press, before turning off automatically. To display all icons constantly, press and hold the
IR button for 3 seconds. Repeat to switch back to auto icon overlay (only visible for 10 sec. max following the use of a button).
7