Silk-n CALLUS REMOVER Mode D'emploi page 4

much force. Switch off the device and check whether the area of skin now has the desired
softness. If not, switch the device back on, rotate over the skin for another 2-3 seconds and
check again. Continue this procedure until you have reached the desired level of softness.
Warning: Stop using the device immediately if the skin becomes painful or red. Warning:
Never use on the skin for more than 2-3 seconds at a time.
4. After you have finished the treatment, rinse the skin clean or use a wet towel to remove the
dead skin cells.
The MicroPedi Instant & Express roller contains delicate components which should be treated
with care. Be especially careful when replacing the MicroPedi Instant & Express roller. Please
note: broken or worn MicroPedi Instant & Express rollers may damage the skin.
Replace the MicroPedi Instant & Express roller when necessary in order to achieve best results.
The rollers can be used several times, depending on how frequently they are used and the
size of the skin area to be treated. Replace the MicroPedi Instant & Express roller when defects
occur or if you feel the roller is becoming less effective. Make sure the device is switched off
before replacing the MicroPedi Instant & Express roller.
1. Pull down the release switch on the side of the device in order to eject the
MicroPedi Instant & Express roller (fig. 3 & 4).
2. Remove the MicroPedi Instant & Express roller from the cylinder (fig. 5) and
dispose of it.
3. Remove the MicroPedi Instant & Express roller from the refill pack (fig. 6) by
pressing against the bottom of the pack with your index finger and catching
the roller in the palm of your hand.
4. Place a new MicroPedi Instant & Express roller in the device and press until
you hear a 'click' (fig. 7 & 8).
5. Once you have placed a new MicroPedi Instant & Express roller in the de-
vice, check whether the roller is properly fastened and make sure no weak or
loose components are visible (fig. 9).
Cleaning the device
1. Switch off the device.
2. Remove the protective cover and remove the MicroPedi Instant & Express roller from the
device. Please note: Do not hold the MicroPedi Instant & Express or rollers under water.
3. Clean the device with a damp cloth and rub it dry with a clean cloth.
4. Now replace the roller and protective cover.
Replacing the MicroPedi Instant & Express roller
5.