Black & Decker CM2040 Mode D'emploi page 99

REPLACING THE SPOOL
(FIGURES P, Q AND R)
• Remove battery from tool.
• Depress the tabs (P1) and
remove the spool cap (P2)
from the spool housing (P3) in
the trimmer head (figure P).
• Replace spool with
BLACK+DECKER model
# AF-100.
• Grasp empty spool with one
hand and spool housing with
other hand and pull spool out.
• If lever (Q1) in base of
housing becomes dislodged,
replace in correct position
before inserting new spool
into housing.
• Remove any dirt and grass
from the spool and housing.
• Unfasten the end of the
cutting line and guide the line
into the eyelet (R2) figure R.
• Take the new spool and
push it onto the boss (Q2) in
the housing. Rotate the spool
slightly until it is seated.
The line should protrude
approximately 4-13/16 inches
(122mm) from the housing.
• Align the tabs on the spool
cap with the slots (R1) in the
housing (figure R).
• Push the cap onto the
housing until it snaps securely
into place.
CAUTION:
To avoid tool
damage, if the cutting line
P
Replacement
spool
Model #
AF-100
P1
Q
Q1
R
R1
protrudes beyond the trimming blade, cut it off so that it just reaches
the blade.
P2
REWINDING SPOOL
(USE ONLY .065 IN. ROUND DIAMETER LINE) (FIGURES S, T & U)
NOTE: Hand wound spools from bulk line are likely to become
tangled more frequently than BLACK+DECKER factory wound
spools. For best results, factory wound spools are recommended.
To rewind spool, follow the
steps below:
P1
• Remove battery from tool.
• Remove the empty spool
from the tool as described in
P3
REPLACING THE SPOOL".
• Make a fold at the end of
the cutting line at about 3/4
inch (19mm)(S1). Feed the
cutting line into one of the
line holding slots (S2) as
Q2
shown in figure S.
• Insert the 3/4 inch (19mm)
end of the bulk line into
the hole (T1) in the spool
adjacent to the slot as
shown in figure T. Make
sure the line is pulled tight
against the spool as shown
in figure T.
R2
11
S
S1
S2
T2
T
T1