Black & Decker CM2040 Mode D'emploi page 64

operation
always wear safety glasses. wear a filter MasK
if tHe operation is dusty. use of rubber gloves
and substantial footwear is recoMMended wHen
worKing outdoors. for HouseHold use only.
warning:
for tube installation or any other reason, wait 10 seconds for the
fan to stop rotating before disassembly.
• Always switch off and remove the battery when:
• The power supply cord has become damaged or entangled.
• You leave sweeper unattended.
• Checking, adjusting, cleaning or working on sweeper.
use sweeper only in daylight or good artificial light.
switcHing on and off (figure e)
warning:
Hands to grip tHe product firMly
wHen switcHing on.
To switch the sweeper on, slide the on/off
switch forward.
To switch the sweeper off, slide the on/off
switch back.
caution:
do not point unit discHarge
tube at self or bystanders.
power coMMand (figure f)
MaX power / MaX runtiMe
The max power / max runtime feature (f1)
is located on the tool handle. It allows you
to optimize the tools performance and
boost the power as needed.
• To choose max power, rotate dial
to setting 6.
cut Hazard. When turning the tool off
e
use botH
f
• To maximize runtime rotate dial to setting 1.
• For a combination of both, rotate dial to setting from 2 to 5.
sweeper operation
caution:
the operation is dusty. Use of gloves, long pants and substantial
footwear is recommended. keep long hair and loose clothing away from
openings and moving parts. tHis sweeper
is for HouseHold use only.
note: ensure the sweeper is switched
off and the battery is removed before
attaching or removing the sweeper tubes.
The sweeper tube must be assembled
to the housing before use. Install battery
after assembly just prior to use.
• Hold the sweeper with one hand as
shown in figure g and sweep from side
to side with the nozzle several inches
above the hard surface. Slowly advance
keeping the accumulated pile of debris
in front of you.
cleaning and storage
warning:
f1 spray water on tHe tool in an atteMpt to clean.
caution:
froM tool.
Use only mild soap and a damp cloth to clean the tool. Never let
any liquid get inside the tool; never immerse any part of the tool into
a liquid. Your Sweeper should be stored in a dry place. Do not store
the tool on or adjacent to fertilizers or chemicals. Such storage can
cause rapid corrosion of the metal parts.
8
Always wear safety glasses. Wear a filter mask if
g
Maintenance
sHocK Hazard. do not pour or
turn off and reMove battery