Télécharger Imprimer la page

Black & Decker CM2040 Mode D'emploi page 4

Tondeuse sans fil avec blocpiles au lithium-ion de 40 v max., balai sans fil avec bloc-piles au lithium, 40 v max, taille-bordure / coupe-bordure avec pile au lithium de 40 v max
Masquer les pouces Voir aussi pour CM2040:

Publicité

Les langues disponibles

Les langues disponibles

the discharge guard frequently and when
necessary replace with blAcK+decKeR
recommended parts only.
9. Mower blades are sharp. Wrap the
blade or wear gloves, and use extra
caution when servicing them.
10. Maintain or replace safety and
instruction labels, as necessary.
This class b digital apparatus complies
with canadian iceS-003.
This device complies with part 15 of the
fcc Rules. Operation is subject to the
following two conditions: (1) this device
may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
NoTe: This equipment has been tested
and found to comply with the limits for
class b digital device, pursuant to part
15 of the fcc Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
however, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
. Reorient or relocate the receiving
antenna.
. increase the separation between the
equipment and the receiver.
. Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
. consult the dealer or an experienced
radio/TV technician for help.
changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the user's authority
to operate the equipment. This class b digital
apparatus complies with canadian iceS-003.
SAVe THeSe INSTRucTIoNS
WARNING: GeNeRAL
SAfeTy WARNINGS ANd
INSTRucTIoNS foR ALL TooLS
• THIS TooL cAN Be dANGeRouS.
follow all warnings and Safety
instructions in this manual. The
operator is responsible for following
warnings and instructions in this
manual and on unit. Restrict use of
this mower to persons who read,
understand and follow warnings and
instructions in this manual and on unit.
• Avoid dangerous environment – don't
use lawn mowers in damp or wet locations.
• don't use In Rain.
• keep children Away – All visitors
should be kept a safe distance from
work area.
• dress properly – do not wear loose
clothing or jewelry. They can be caught
in moving parts. Use of rubber gloves
and footwear is recommended when
working outdoors.
• use Safety Glasses – Always use face
or dust mask if operation is dusty.
• use Right Appliance – do not use
lawn mower for any job except that for
which it is intended.
• uSe of exTeNSIoN coRdS Make
sure the extension cord is in good
condition before using. Always use
the proper size extension cords with
the tool – that is, proper wire size for
various lengths of cord and heavy
enough to carry the current the tool will
draw. Use of an undersized cord will
cause a drop in line voltage resulting
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
More not more
Than Than
0
-6
18
6
-10
18
10
-12
16
12
-16
14
in loss of power and overheating. for
proper size cords see chart below.
• cHeck foR dAmAGed pARTS.
before further use of the mower, a
guard or other part that is damaged
should be carefully checked to
determine that it will operate properly
and perform its intended function.
check for alignment of moving parts,
binding of moving parts, breakage
of parts, mounting, and any other
conditions that may affect their
operation. A guard or other part that is
damaged should be properly repaired
or replaced by an authorized service
center unless otherwise indicated
elsewhere in this manual.
• RepAIRS ANd SeRVIce. Repairs,
maintenance and any adjustments
not specified in this manual should
be performed by blAcK+decKeR
authorized service centers or other
qualified service organizations, always
4
26-50
51-100
101-150
American Wire gage
16
16
16
14
16
14
12
not Recommended
14
12
12

Publicité

loading

Ce manuel est également adapté pour:

Lsw36Lst136