Black & Decker CM2040 Mode D'emploi page 10

NoTe: Make sure the cord is located on
the front of both handles. if it is not it may
result in the cord tangling and the inability
to easily store the mower (figure i).
• From the outside
of the upper
handle (3), slide
the lever bolt
through the holes.
• Slide the washer
over the bolt of the
lever and loosely
assemble the
entire assembly
with the nut.
• Rotate the upper
handle into its
operating position.
• Close the lever. If it is too tight or too
loose, open the lever and the nut to
adjust the clamping. check the levers
by closing them. They should be tight
enough so the handles are held firmly,
but loose enough so the levers can be
fully closed. Adjust by opening the lever
and turning the nut until the handles are
secured.
SecuRING THe moToR cABLe
(fIGuRe j)
CAUTION:
ATTAch cAble SO
ThAT iT dOeS nOT becOMe
STReTched OR pinched in The
jOinTS Of The hAndleS dURing
USe OR fOlding. ThiS cAn cAUSe
dAMAge TO The cORd.
The motor cable (22) has to be fixed to
the handles using the cable restraints (23)
that are already attached to the handle.
To clip the cable to the handle:
• place the handles in operating position,
see "Attaching lower handle" section.
• Run the cable up the front of the lower
and upper handles.
• pull back the cable restraint.
• Slide the motor cable under the clip
and ensure it is fully held in place by
the restraint.
j
23
I
22
10
BAGGING
• ensure the side discharge attachment
(27) (figure m) and the mulching insert
(26) (figure L) are removed from the
mower before bagging.
• lift the rear door cover (9) and place
the grass collection bag (8) onto the
mower so the bag hooks (24) rest on
the lugs (25) as shown in figure k.
Then lower the rear door cover.
k
9
muLcHING
• ensure the side discharge attachment (27)
and the collection bag (8) are not attached.
• lift the rear door cover (9) and slide the
mulching insert (26) fully into the mower
as shown in figure L.
• ensure the rear door cover fully closes
before turning mower on.
L
SIde dIScHARGe
• ensure the collection bag (8) is removed.
• lift the rear flap (9) and slide the
mulching insert (26) fully into the mower
as shown in figure L.
• lift the side flap (28) and hook side
discharge attachment (27) onto the
mower as shown in figure m.
• Release the side flap and ensure
the attachment holds in place before
turning mower on as shown in the insert
of figure m.
8
24
25
26