Beefer XL Chef Notice D'utilisation Et D'installation page 38

6.2 CONNECTING THE NATURAL GAS LINE
ATTENTION:
natural gas device to a natural gas line. He will also do a leak test and seals the
line.
Accordingly, no gas line or pressure regulator is included in the scope of delivery.
These have to be selected by your authorized service technician who installs
your device in accordance to the valid guidelines.
To-Do list for the authorized service technician:
- Check the burner ignition
- Attached gas-carrying parts must be sealed for the user in
such a way that the seal is temperature-resistant.
- When installing the device, the minimum clearances of 60 cm to both
sides and the rear wall of the Beefer must be observed
- The correctness of the device information sign and the type
plates must be checked
- Pressure: 7" WC - Input: 13.700 BTU/h
Ensure that the length of the gas line is properly selected and its length is
in accordance with requirements. Lay the gas lines in such a way that the
equipment isn't touched, is not nicked or is under tension, and cannot be
damaged at any place along the lines. Ensure that the gas connector is correctly
seated, and inspect for gas leaks after placement.
7 INSTALLING THE BATTERY
This appliance requires a battery so that you can ignite the Beefer with the
electrical ignition button. Proceed as follows in order to install the included
battery or to change a spent battery:
38
Only an authorized service technician is allowed to connect your