Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.1 CONNECTING THE LPG BOTTLE
If you are unsure about connecting the cylinder (LPG bottle) and the gas lines, or
have doubts about the leak tests, please bring in a specialist to connect to the gas
supplied components.
The installation must conform with local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and Handling
of Liquefied Petroleum Gases, ANSI/NFPA 58; or the Natural Gas and Propane
Installation Code, CSA B149.1; Propane Storage and Handling, CSA B149.2; or the
Standard for Recreational Vehicles, ANSI A119.2/NFPA 1192; and Recreational
Vehicle Code, CSA Z240 RV Series, as applicable. Fuel supply cylinders (LPG
bottles) must be constructed and marked in accordance with the specifications
for propane cylinders of the U.S. Department of Transportation (DOT), or CAN/
CSA B339.
The LP gas supply cylinder (LPG bottle) to be used must be constructed
and marked in accordance with the specifications for LP gas cylinders, U.S.
Department of Transportation (DOT) or the Standard for Cylinders, Spheres and
Tubes for the Transportation of Dangerous Goods, CAN/CSA-B339.
The cylinder (LPG bottle) must be provided with a shutoff valve terminating in
a cylinder valve (valve on the LPG bottle) outlet specified, as applicable and a
safety relief device having a direct communication with the vapor space of the
cylinder (LPG bottle). The cylinder (LPG bottle) supply system must be arranged
for vapor withdrawal, and the cylinder (LPG bottle) used, if in excess of 2.2 lb
(1.00 kg) must include a collar to protect the cylinder valve (valve on the
LPG bottle). The hose line must not exceed the recommended length of 1.50 m.
Place the LPG bottle vertically in a safe state far enough away from the Beefer
that the gas lines are not under current and do not touch the Beefer at all.
Ensure that the LPG bottle is far enough away that the heat radiation of the
Beefer does not reach the surfaces of the LPG bottle or the gas lines.
ATTENTION:
Use only the pressure regulator and gas line which came with
the gas grill. When replacing components, only use parts from the same
manufacturer and ensure that the correct pressure is used for the appliance.
1. Screw the pressure regulator to the valve on the LPG bottle if a pressure
regulator is part of the delivered components (only when designed for LPG).
Use the right tool for this.
2. Always exchange the LPG bottle away from all ignition sources. Bring the LPG
bottle to a specialist in order to have it refilled.
37
Publicité
Table des Matières
